Posted by Cliffton D on January 15, 2015 at 10:42:46 from (174.239.32.107):
Hello everyone!
Thanks to a lot of help from the archives I just came off a instillation of a c153 on my little farmall C. I love the tractor! Thanks to all who contributed to those forums. Everyone was right.... It wasn't that complicated but the little details drove me nuts. I think it turned out well.
On to the topic of my post. I recently aquired another little c very reasonably and got it to run after sitting to what I could only guess a couple decades. I've already got my eye on this engine. It's quite possible to put the overbore kit in the c113 to make it 3 1/4". The c135,c146, and c153 all use an updated head with more air flow and a different manifold. I guess what I don't know us if the head bolt pattern changes as well with the redesigned head??
It seems you could gain a bit if it was possible. Has anyone tried?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.