Posted by JD Seller on September 07, 2013 at 14:29:08 from (208.126.196.144):
Filled up the car with gas yesterday. Local station that also runs delivery trucks had a letter on the counter for any customers. Basically it says that there are going to be "new" fuel blends at the pumps due to new rules.
Current blends at the pumps, cheapest to highest.
89 Octane 10% ethanol 87 octane zero ethanol 91 octane Premium zero ethanol
New blends: 87 octane 10% ethanol 89 octane 10% ethanol 91 premium zero ethanol
The problem is that I usually run the 87 in the car and larger small engines. 91 octane in the small two cycle engines (chainsaw, weed eater, etc.)
So to get away from the (junk) ethanol I would have to buy the 91 octane premium that is currently 40 cents higher per gallon. The old 87 octane was just 10 cents higher.
I am sick and tired of the tree huggers and the corn ethanol business TELLING me what I want to buy. If you want ethanol BUY all of it you can/want.
I personally dislike an inferior product that causes problems in the motors/engines that we are forced to use it in. I get to repair too many gas engines that have fuel issues caused by ethanol. My car gets much lower fuel mileage with the ethanol blended fuel is it. (28-30 no ethanol and 23-25 with ethanol) So how is that creating lower emissions when you have to burn more fuel to get the same work done???
Have any of the rest of you guys heard of this??? Is it state or Federal rules that have changed???
I guess I will just have to keep getting rid of more gas motors. I am not going to fool with junk/ethanol fuel issues anymore than I have too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
