Posted by Roger Mattingly on September 07, 2013 at 23:34:58 from (12.21.188.3):
Hey Folks, I desperately need some help identifying an old Ford tractor I recently purchased. The person I bought the tractor from thought it was a Ford 3000. It was only after locating a Ford 730 Loader and driving the 500 miles round trip to Tn that I realized, I'm most certain that I don't have a 3000. The Loader was removed from a 3000 and that tractor was much smaller than mine. When I arrived home and started pulling some measurements, the loader will need some serious modifications. The frame appears to be too short to reach my rear axles by at least a foot or so, I will have to weld on some hefty extensions. I noticed that about 6" was because of the heavy chunk of steel my tractor has located over my front axles (below the radiator shroud)that doesn't have a hole for my splined shaft to even go thru. I will have to take the cutting torch to make an access point. Someone else mentioned they thought I had a 4000 Row Crop given the tall height of the tractor. The Row crop would explain why there isn't a hole for the splined shaft up front, given it should be a field tractor. It is an 8 speed, 3 Cyl Diesel. The stamped numbers from the right side block (behind the starter) read: 5D 30 B 3 and 4 stamped on top of each other,then 1012C 10823551 16 Any help with identifacation of this tractor would be greatly appreciated!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
