Posted by ericlb on June 24, 2016 at 08:31:25 from (67.142.173.26):
i need help, on this truck after fighting this same problem for 3 years spending over a grand on a 200 dollar clutch replacement im out of ideas, the last thing is installing a new big spring under the dash on the 2 pins, my truck didnt have one,it broke some years ago and i never got it replaced ,got the dash and instrument panel back out for the 100th time now ,how in the heck do you get this spring on the 2 pins??? brake spring pliers,and the biggest bar i can fit under there wont even move it and i need 4 inches, i have the pedal piece disconnected from the piece that had the bushings on it that the spring attaches to to get more movement but it dont help much, tired of fighting this problem, and ive had this truck its whole life, found another truck but im going overboard, its an ex fire truck showing 22000, good, and like most fire trucks its in decent shape sort of, its been parked for 20 years that i know of, its a c-60, tandem axle with a 5 +4 transmission, [ yes i know how to drive one] but this sucker is a gas job and its engine at least from ground level makes my 454 look like a lawn mower have no idea how big it is i thought they put 427's in those trucks, probably 2 mpg if that, really done want to go there but its all i can afford , any ideas how to fix what ive got? the problem is a binding clutch pedal every single part of the pedal assembly is now brand new, as is the clutch and flywheel, linkage, and bell crank and the ball studs that rides on,
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
