Posted by FarmallCT on April 12, 2017 at 18:34:10 from (50.28.150.217):
Hi everyone,
So I recently helped start a 4-H tractor club and we are trying to have a little plow day type thing on friday with myself and a few of the kids in the club and FFA.
I am trying to figure out how much fuel the tractors will burn. I don't have that good of an idea since at fairs, they are running on and off and hardly at full throttle or under a heavy load.
The tractors I have that I am considering bringing are a 1937 F-12 (with overdrive), a Farmall H, or a John deere B. This will be with a 2 bottom plow, and a friend is bringing their JD A to pull the 3 bottom plow that I have. We have to drive maybe 2 miles down the road to the farm, and hoping to plow for maybe 2 hours. We figure just drive them since it is a pain to get them off the gooseneck trailer we have. From those who have done this before, about how much fuel do you burn per hour?
Also, is there anything that should be done to the plows in advance? I know I'll be greasing them, and one of them has had the quick release removed so not sure if I have time to fix that, and it is missing the bracket for one of the disks/coulters so one of them is not on the 3 bottom. Will either of those be a problem?
Any other advice is appreciated. I have little experience plowing, as the closest plow day is 2 hours away in New Hampshire with the New England IH chapter so I haven't tried to attend that one.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
