Posted by Case30Deutz06 on October 07, 2020 at 16:11:36 from (146.112.44.92):
In Reply to: Re: 10006 Deutz posted by Case30Deutz06 on October 06, 2020 at 16:07:25:
Adding two pictures as promised. One shows the stickers on the dash that show the shift patterns of the two levers. Pretty straightforward. Sometimes if tractor has sat outside a while the stickers are faded and unreadable. Note on the range/reverse lever (left lever) that "Z" is low and "N" is high. German that I don't know. There are two lows in the pattern. One directly in front of high for easy hi-lo shifting, and one in back of reverse for for easy shifting from forward to reverse (it is synchronized). Both low positions are the same speed....this confuses one of my friends.
Also is a picture of the top of the shift levers also showing the shift pattern.
Please don't hesitate if you have more questions. I expect next might be question on the lever for the creeper and the lever for the PTO setting.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
