Posted by gwayne1962 on October 23, 2023 at 11:46:26 from (150.220.11.98):
I bought my 560 a little over a year ago...seller did not have alot to say about it...bought it for a good price and have been using it around the farm mainly for moving hay and brush hogging. The most recent issue that I have, is when I am pulling up with the front fork loader and sticking the bale....once the fork is in, and i try to take the 560 out of gear, the shifter is stuck in gear...
This past weekend i was moving hay to a new holding area and when i would try to push the bales together..once I had the bale down and up against the bale on the ground..same thing...could not get the tractor out of gear.....sometimes I could raise the bale up high and the tractor would move a little and could shift it out.
But when I go back to get the next bale out of field...if I did not pull the shifter out of gear before the loader was all the way in the bale same thing...could not pull shifter....I could shut the tractor off and get it out of gear...but sometimes it was a hard pull to get shifter to move out of gear, which didnt seem good either.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
