|
Tractor Talk Discussion Board |
berger transit
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 4020 on August 12, 2006 at 10:06:44 from (216.139.97.148):
I have a Berger instruments transit,level.Can I check to see if it is reading correct? We are sitting up cement forms in our new shed and when we started again this morning the transit was not level.The bubble was off to the left, but when I turned the transit one half turn, it was off to the right so I thought the bubble needed leveled and did ajust it .Now my readings are off I think, did I mess the transit up? We were getting about done with the grade, hope I dont have to start over, but will if I have to,to get it right. 75'x36'x8" THANKS for any help again!
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
