|
Tractor Talk Discussion Board |
Re: berger transit
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by smiley on August 12, 2006 at 15:44:57 from (4.156.174.214):
In Reply to: berger transit posted by 4020 on August 12, 2006 at 10:06:44:
4020,
If it"s thhe 3 screw type, you"ve just got to play with it to get the bubble centered.
If it"s the 4 screw, it depends on what you adjusted.
Did you adjust the vial with an adjusting pin or screwdriver, on the scope, or just the leveling thumb screws on the base? If you adjusted the vial, you will have problems.
If it has 4 thumbscrews, turn the scope directly over one pair of adjusting screws and adjust until the bubble is level. Now turn it 1/4 turn over the other screws and level the bubble. Now turn it 180 degrees and see if your bubble is still centered. check it a couple times in all 4 directions over each set of screws. if the bubble remains centered, your all set. If you can"t keep it centered the vial needs adjustment. You do it the same way except you adjust the vial, only 1/2 way then readjust the leveling screw, then turn it 180 degrees and it should be close. You may have to do it several times to get it dead nuts.
Don"t shoot a benchmark with it not being leveled though, because as soon as you swing it WILL be out and your grade will be wrong. If you can"t get it in, you can always use the old garden hose trick with a short piece of clear hose on one end.
Good luck,
Smiley
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
