|
Farmall & IHC Tractors Discussion Board |
Re: Need help fine tuning carb. on a 47 Super A (Zenith)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on February 18, 2003 at 19:13:03 from (207.178.96.214):
In Reply to: Need help fine tuning carb. on a 47 Super A (Zenith) posted by Greg on February 18, 2003 at 12:17:09:
Your carb was made for kerosene or distillate, rather than gas. Doesn't mean it won't run on gas. The gas carb has a fixed jet with a plug in place of the T adjustment. The top screw is the idle adjustment. When you get the float set right, turn the T handle in until you lose rpm and the turn it out until it runs smooth. To adjust the float you have to dissasemble the carb, and turn the throttle body upside down, From the top of the gasket to the top of the float the measurement it 1 5/32 inches. This is a critical measurement on the models with the fixed jet, as they tend to run rich. Since you have a T jet, you may be able to fine tune it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
