|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Re: Still need help is thi
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on June 25, 2003 at 09:59:30 from (165.170.128.65):
In Reply to: Re: Re: Re: Re: Re: Re: Still need help is this a posted by sue ebbert on June 25, 2003 at 09:18:46:
Not certain it's a Continental Y69 Sue - just a guess. But it sure LOOKS like a Continental engine, and the Y69 was one of their smaller 4 cylinder flatheads. However there's also an N56, N62, Y91, Y112 and others. (Incidentally the N62 powered the little Allis Chalmers "G" tractors.) All these engines were commonly used as a power unit for balers, small combines, welders, pumps, forklifts, etc. You need to find the name plate (or other unique identifier) to establish exactly what engine that is. Continental still operates under the name Teledyne Wisconsin. Also there's still places around that stock repair parts, manuals, etc. even though the engines have long gone out of production. A When you ask for a regulator, do you mean for the battery charging generator or the power generator? If the former, it's probably the same 6 volt, 4-terminal regulator used on early 50's era Farmall gas tractors (Cub, A, C, H, M). However the power generator - if it requires regulator - will be tougher. Need ALL the nameplate data off the generator head, and then hope the mfr is still in business or a motor shop can cross to it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
