|
Farmall & IHC Tractors Discussion Board |
300U power steering leak....help please.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by brian koczur on September 18, 2006 at 14:48:14 from (156.98.4.11):
Howdy all, First post here, but have enjoyed what a friendly bunch of folks share their know how. Anyway, I just got a 300u and have been fixing as things break. The leak I'd like to fix is on the bottom of the power steering. The shop manual (If I'm reading correctly) shows this are as the "Shims". The bolt heads here have retention tabs. Is it OK to just tighten them? Can some gaskets be cut? It appears to have two of these shim plates. If I remove, will all kinds of clean parts bounce off my trousers and into the dirt at my feet where I'll never find them?
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
