|
Farmall & IHC Tractors Discussion Board |
Re: M engine - How would you build it?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by georgeky on August 08, 2007 at 08:42:54 from (64.12.117.137):
In Reply to: M engine - How would you build it? posted by CenTexFarmall on August 08, 2007 at 07:52:35:
I would just go with a 8000 foot over bore piston and sleeve kit if it were mine. I have two with these in them and both have plenty of power for a working M. One has 8000 foot M&W Add-Powr pistons and the other has the IH Firecraters in it. I use them both on the farm and can pull a 15 batwing heavy duty bush hog, 3 bottom plow, 10 foot heavy disk, and lots of tools with both. I have also used the 48 to pull with and it has never lacked for power. If your M has the 8060 head that is the high compression M head. Just depends on how hot a tractor you waqnt. The 450 cam, carb and head will increase power and fuel economy.
Replies:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
