|
Farmall Tractors Discussion Board |
Alternator Conversion Wiring Diagram
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Bob G. on January 27, 2000 at 05:26:41 from (205.188.199.47):
I have been gone so I am a little late with a response to this subject. The question was asked about the engine not shuting off once the ign. switch was opened. The answers were haveing to do with the warning light starving the engine for juice. Respectfully, I think that even if this were the case it would still kill the battery over time. Alternators need juice in order to put out juice, they aren't like generators in this respect. I think the wire going to #1 is to feed the rotor with current via the internal voltage regulator, and the warning light is to tell if the alternator is charging. I also think there is a Diode to keep the current from feeding back to the ignition, allowing the engine to stop when the ign switch is opened. Does anybody have a internal diagram of the alternator we are looking at?? By the way very nice wiring diagram Thanks to Bob M.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
