Farmall & IHC Tractors Discussion Board |
FARMALL 130 12 VOLT CONVERSION COMPLETE
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeremy on November 24, 2000 at 17:44:20 from (209.240.200.114):
Well, just getting in from working on "OLD RED". Putting the alternator on was the most time consuming part. Not sure if I was successful or not. The tractor turns over beautifully now, even seems like it sounds better. However, I noticed the ammeter just barely shows charge when I pull out (turn on) the kill switch. When the tractor runs it shows charge. When it's off it shows zero. I didnt have time to hook up the lights yet. Nothing shows discharge. I thought it would show discharge when I turn the kill switch on before I start it, then show charge when it's running. I wired it to Bob M's diagram of the M. Only difference is I didn't get a resister, just a 12 volt coil. For the warning light I used a regular indicator light, which is on from the time I pull out the kill switch to the time I push it in. Would that have anything to do with the ammeter reading, or is it something else? Does it sound like I have a problem at all? I appreciate anyone's response. Thanks in advance.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|